Skip to content

Scanner barcode display echo

Note: This feature is only supported on scanner firmware v2.3.0 and higher and Gateway v.1.8.0 and higher.

When you scan a barcode with MARK Display, the content of the scanned barcode displays on the MARK Display's screen for 5 seconds after which the screen reverts to the previous message.

The MARK Display screen template used in this feature is PG1A.
To learn more, see Screen templates.

Enable the Scanner barcode echo feature in the configuration file

  1. On Insight Webportal, under Device Visibility, select Configurations.
  2. At the top right, click the + icon to add a configuration.
    CreateNewConfiguration
  3. Select Gateway and click Next.
    CreateNewConfiguration
  4. Under the Device Settings, select Show barcode content on display.
    BarcodeEcho
  5. At the bottom of the page, click Next.
    The modal Assign a Name for the Configuration window displays.
    AssignName
  6. Type in the name of your configuration and click Next.
    The modal Apply the Configuration window displays.
    ConfigLisst
  7. Scan the Configuration barcode to apply the configuration to the connected device.
  8. Click Save.